We take your product from concept toa working prototype.a working prototype.
From circuit concepts to production-ready systems, we guide innovators through design, prototyping, and manufacturing.
TRUSTED EXPERIENCE FROM
Leading institutions & organizations
One team, the whole hardware stack
Electronics, firmware and mechanics handled together, so nothing breaks at the hand-off between them.
Product architecture & system design
From a rough concept to a complete technical specification and BOM.
Custom hardware & PCB design
Multi-layer layout in KiCad and Altium, low-power and low-noise, built for DFM.
Industrial design
Enclosures and housings designed around your electronics, and around production.
Embedded firmware development
C/C++ on Zephyr and nRF Connect SDK for sensors, BLE and connected devices.
Prototyping & R&D support
Rapid prototyping, board bring-up, debugging and custom automated test jigs.
Legacy product support & re-engineering
Stuck with a product and no source files? We recover it and give you back control.
Project portfolio
Here is a selection of my work, showcasing experience that spans from high-tech R&D and full-stack IoT development to industrial-grade automation and design for manufacturing.
10-year Zigbee environmental sensor (Palroc R&D)
In-house Zigbee sensor for humidity, temperature and illuminance built around an nRF54L15. Draws ~10 µA average and runs from a single Li-SOCl₂ 1200 mAh cell, giving 10+ years of life while reporting every minute.
Full-stack IoT gas meter (Palroc R&D)
This in-house R&D project involves the complete design and prototyping of an end-to-end IoT system: a multi-sensor gas and particle meter aimed at enhancing safety for first responders. This project demonstrates a broad scope of capabilities across the entire IoT technology stack.
View project
Low-noise amplifier (EPFL advanced NEMS laboratory)
Designed and implemented low-noise transimpedance amplifier circuits for nanoelectromechanical systems (NEMS). This R&D project involved creating and assembling 4-layer PCBs using Altium to optimize signal integrity and minimize parasitic capacitances, pushing the boundaries of low-level signal detection.
Industrial automation workstation (Jabil)
During my internship at Jabil Packaging Solutions, I gained hands-on experience in industrial automation. My primary project involved the complete lifecycle of a fully automated factory workstation, from initial OnShape CAD design and engineering to manufacturing and implementation, utilizing COTS pneumatic actuators.
Confidential projects
Additional consulting work completed under Non-Disclosure Agreements (NDAs):
- •Consumer electronics: Hardware design and wireless connectivity development for a Swiss startup in the consumer electronics sector.
- •Sports technology: Embedded electronics development for precision measurement devices in sports applications.
- •Hospitality industry: PCB redesign and optimization consulting for hospitality sector electronics.
Expert electronics consulting
Palroc is an engineering studio passionate about bringing innovative ideas to life through cutting-edge design and engineering excellence.
Meet the team
Oriol Reverté
Founder, lead hardware engineer
Schematics, PCB layout and firmware, taken from a concept to hardware that survives manufacturing.
Alex Amat
Associated industrial designer
Enclosures built around the electronics, so products fit, seal and stay cheap to produce.
Start your project today
Ready to bring your electronics project to life? Let's discuss your requirements and explore how we can help you achieve your goals.
Send us a message
Free Initial Consultation
Not sure where to start? Schedule a 15-minute consultation to discuss your project requirements and get expert guidance.
Contact information
Phone
+34 711 23 20 51Office
Passeig Venta Nova, 10, Despacho 12, 43894 Camarles, Tarragona
Hours
Mon-Fri 9AM-6PM CET
Quick Response Guarantee
We respond to all project inquiries within 24 hours during business days. For urgent consultations, please call us directly.